Installation of LED downlights in elderly care centers

Prodigital Technology Corp. 12F, No.358 Chung Hwa road, Chu pei city, Hsin chu county, Taiwan R.O.C.

This time we introduce the performance of fully-filled LED soft strip lights. The original LED step lights used sleeved LED soft strip lights and LED glue strip lights. These two models are known in the industry as having an IP65 rating, but this approach is not recommended for use in outdoor engineering cases or LED landscape cases. Difference description: A.LED sleeve soft strip lights are actually composed of bare board + silicone sleeve, achieving dustproof and waterproof. 1. When the LED is hit by a frontal impact, the silicone sleeve is soft and does not protect the internal LED. 2. The inlet end of the casing must be properly protected to avoid water intrusion due to pulling and rupture after construction. 3. When the waterproofing of the on-site wiring is poor, water or moisture will penetrate the copper wire's cooling and heating effects, causing siphonage and water intrusion. B. LED glue strip lights are covered with a layer of PU glue on the exposed LED board to achieve dustproof and waterproof on the front. 1. The main disadvantage of the LED flexible strip light is that the back is not waterproof Outdoor lighting mainly depends on the quality of the product itself + the quality of on-site construction to extend its service life. Factory customization Recommended length: DC24V length 20 meters double-ended power supply, DC12V length 10 meters double-ended power supply Color temperature range: 2700K ~ 6500K Power range: 5W ~15W/meter, single row Waterproof level: IP68 Outlet method: 2 wire length < 10 meters Leave a waterproof layer on the front and back of the PCBA LED soft board, and tightly cover the LED and soft board. The wires are also wrapped in adhesive material, and the outer layer has a heat-shrinkable sleeve to enhance waterproofing and reduce the pulling force that may cause the adhesive material to break. After learning about the product, go to the construction site to see actual performance. Removing glue from lamp power wiring hole cover Clear the original LED glue strip lights and LED tube soft strip lights operations, Site bonding requires silicone to reinforce waterproofing Use a scraper to remove it and it will almost become crispy! Removing old silicone takes a lot of time!! Take out the arrangement position of LED soft strip lights Peel off the 3M adhesive on the back and press along the edges to fix it! After pressing, apply glue to the power hole. The 3M adhesive tape is only for temporary fixation. In actuality, the upper and lower edges of the LED flexible strip lights and the joints with the wall must be firmly covered with a layer of glue to prevent them from falling off. Fixed completed appearance Actual effect at night LED soft strip light products https://www.prodigital.com.tw/en/product_cg257608.html Introduction to various types of LED soft strip lights https://www.prodigital.com.tw/en/hot_362663.html https://www.prodigital.com.tw/en/hot_471661.html Taiwan Hsinchu Community Landscape LED Step Light LED Outdoor Full Glue-filled Soft Strip Light Construction Case 2024-06-27 2025-06-27

Prodigital Technology Corp. 12F, No.358 Chung Hwa road, Chu pei city, Hsin chu county, Taiwan R.O.C. https://www.prodigital.com.tw/en/hot_471661.html

Prodigital Technology Corp. 12F, No.358 Chung Hwa road, Chu pei city, Hsin chu county, Taiwan R.O.C. https://www.prodigital.com.tw/en/hot_471661.html

https://schema.org/EventMovedOnline https://schema.org/OfflineEventAttendanceMode

2024-06-27 http://schema.org/InStock TWD 0 https://www.prodigital.com.tw/en/hot_471661.html

Prodigital Technology Corp.

Home Hot News Application articles / Other Installation of LED downlights in elderly care centers

After drawing simulation and on-site light test, the LED downlight can also replace the light steel frame.
The installation of the LED downlight can improve the uniformity and softness of the light.
Flat panel lights and light steel frame tubes can also achieve the same effect
but the number and location cannot be as uniform as the configuration of the lights.
The effect of the LED lamp is practicality, too dark and too bright, and the wrong position is a mistake.

Lamp installation planning

Pension center installation
Mainly use 12-watt LED downlight to replace LED tube and light steel frame tube
Use flat panel lights to replace LED light steel tubes in secondary areas
It is recommended to plan and configure a 12-watt LED Downlight

LED Illumination Simulation

12瓦 OSRAM LED崁燈模擬效果

實際安裝效果

Lamp installation planning

The nursing center's demand for the illuminance of the downlight on the ground. LED Illuminance Measurement

2F &3F restaurant

LED Downlight Application

LED Downlight Application

kitchen

LED Downlight Application

corridor

LED Downlight Application

LED Downlight Application

LED Downlight Application

視聽室

LED Downlight Application

Open the toilet

LED Panel light Application

General toilet

LED Downlight Application

LED Downlight Application

LED Downlight Application

Social room LED Panel light Application LED Downlight Application

Different room configuration, install the lamps according to the needs to get the maximum effect LED Downlight Application

LED Illuminance Measurement

LED Illuminance Measurement

LED Downlight Application

LED Downlight Application

LED Downlight Application

Previous Back to List Next