Use LED high-bay lights to plan foreign CNC factories!
Time to review purchases from European countries in February 2018.
After professionally inquiring about customer needs, of course, you need to ask the key points, in order to know the needs of the simulation at the right time.
(This point is very important)
Buying things abroad, in addition to shopping, you need to know where the factory's profession is.
for example:
1. Is the specification clear (you can see the specifications after reading this article)
2. Does the use of materials stabilize the product?
3. Is it suitable for the place of purchase?
4. Is it easy to install and maintain?
5. Is it easy to transport?
Based on the above points, customers need to use our professional planning and suggestions for products, and let customers know at the right time.
We don't just sell lamps to customers, we also need to let customers know that we don't just use a light in the simulation.
Return to the theme:
At the beginning, the customer only proposed which kind of lamp to replace with 7 meters high. (At this time, the inner OS... can replace the solution too diversified)
After a serious conversation, you need to know the needs of the place and the illumination, otherwise the specifications and prices can only know the budget.
It is not very friendly to the end user.
Finally, the customer provides more detailed information, as follows
The space is equipped with new lighting for the new plant area, which is 66 meters wide, 18 meters high and 7 meters high.
Need to reach 200Lux in the green area, to avoid the brightness is too low. (85cm high)
After converting the analog data, it is recommended to use 120W LED high-bay lights (Zhongguangjiao)
In addition to the simulation of 80 watts / medium angle, 100 watts / medium wide angle, 150W / wide angle for comparison,
The number of turns can be from 72盏 to 36最后 at the end.
Only filter the brightness of the luminaire, can't understand the actual demand, and finally buy it according to the budget.
Finally, the people on the scene are patient.
Multiple comparison methods can save a lot of trouble and future maintenance costs.
The light is not broken, it is not dark, it is equal to broken, how is this trap always in the middle.
(If you have used a traditional E40 75W large spiral bulb or an E40 LED large bulb,
Even used LED patio lights, floodlights still feel not OK, please seriously consider the following questions!)
The simulation is to let the terminal know the following questions:
1. Is the illumination sufficient (how much?)
2. Is the dark area too obvious (how to tell?)
3. Installation location and power configuration in advance planning (power saving or more power consumption?)
4. Can the old and new lights be adapted? (Used is very disappointing, not used, afraid?)
5. Is the illumination as expected? (What kind of lamp was it?)
After the simulation and professional advice, the final state of the simulation will be approached after installation.
The maximum error is 10%.
Illuminance difference map
Share actual app photos
It is recommended to start directly with 120W, not because of power consumption.
In fact, for a general CNC factory or a storage area. (In fact, it can be said to be a universal specification)
There are two options for the same 120W option:
Hanging type / E40 lamp holder
1.Hanging type - suitable for C-shaped steel, with chain to adjust the height of the lamp.
2.E40 lamp holder long type - suitable for taking the original mercury lamp holder.